Jobscript

General

A jobscript can be used to submit the job you wish to execute to a batch system. It is similar to a sh-file and generally uses the same format, but is more powerful. Besides shell commands, you can put the so called magic cookie #BSUB. This allows you to specify a lot of parameters, e. g. the time and memory your application requires or - if your code runs in parallel - the number of compute slots to employ.

#BSUB Usage

To use the magic cookie, start a new line in your script with "#BSUB". Following that, you can put one of the parameters shown below, where the word written in <...> should be replaced with a value.

The big advantage of jobscripts is that the parameters that are prefixed with "#BSUB", are treated just like command line arguments. By setting them inside your jobscript already, it's easier to adjust them or look them up later.

Job Submission

$ bsub < jobscript.sh

Note that, when you submit your job to the batch system as shown above, it may take some time before it leaves the queue and starts running. This waiting time depends on the current workload of the machines, as well as the time and memory you asked for in your jobscript. The rule of thumb is: the more resources your job needs (execution time, memory), the longer it will be queued.

You can always check the current status (pend or run) of your submitted jobs with the following shell command. It also prints the job ids.

$ bjobs

In order to remove a job that you submitted, you can type this command:

$ bkill <job_id>