In order to solve a problem faster, work can sometimes be executed in parallel, as mentioned in Getting Started. To achieve this, one usually uses either a Shared Memory or a Distributed Memory programming model. Following is a short description of the basic concept of Shared Memory Systems and Distributed Memory Systems. Information on how to start/run/use an exisiting parallel code can be found in the OpenMP or MPI article.
Shared Memory programming works like the communication of multiple people, who are cleaning a house, via a pin board. There is one shared memory (pin-board in the analogy) where everybody can see what everybody is doing and how far they have gotten or which results (the bathroom is already clean) they got. Similar to the physical world, there are logistical limits on many parallel units (people) can use the memory (pin board) efficiently and how big it can be.
In the computer this translates to multiple cores having joint access to the same shared memory as depicted. This has the advantage, that there is generally very little communication overhead, since every core can write to every memory location and the communication is therefore implicit. Futhermore parallelising an existing sequential (= not parallel) program is commonly straight forward and very easy to implement, if the underlying problem allows parallelisation. As can be seen in the picture, it is not practical to attach more and more cores to the memory. Therefore this paradigm is limited by how many cores can fit into one computer (a few hundred is a good estimate).
For parallelizing applications, which plan on running on these kind of systems, Open Memory Programming (OpenMP) is commonly used in the HPC community.
Distributed Memory is similar to the way how multiple humans interact while solving problems: every process (person) 'works' on it's own and can communicate with the others by sending messages (talking and listening).
In a computer or a cluster of computers every core works on it's own and has a way (e.g. the Message Passing Interface (MPI)) to communicate with the other cores. This messaging can happen within a CPU between multiple cores, utilize a high speed network between the computers (nodes) of a supercomputer, or theoretically even happen over the internet. This sending and receiving of messages is often harder to implement for the developer and sometimes even requires a major rewrite/restructure of existing code. However, it has the advantage, that it can be scaled to more computers (nodes), since every process has it's own memory and can communicate over MPI with the other processes. The limiting factor here is the speed and characteristics of the physical network, connecting the different nodes.
The communication pattern is depicted with a sparse and a dense network. In a sparse network, messages have to be forwarded by sometimes multiple cores to reach their destination. The more connections there are, the lower this amount of forwarding gets, which reduces average latency and overhead and increases throughput/scalability.
Since every communication is explicitly coded, this communication pattern can be designed carefully to exploit the architecture and the available nodes to their fullest extend. It follows, that in theroy the application can scale as high as the underlying problem allows, being only limited by the network connecting the nodes and the overhead for sending/receiving messages.
This really depends on the problem at hand. If the problem is parallelizable, the required computing power is a good indicator. When a few to a hundred cores should suffice, OpenMP is (for existing codes) commonly the easiest alternative. However, if thousands or even millions of cores are required, there is not really a way around MPI. To give a better overview, different pros and cons are listed in the table below:
|Shared Memory (OpenMP)||Distributed Memory (MPI)|
|Easy to implement||scales only to 1 node||scales across multiple nodes||harder to implement|
|shared variables||inherent data races||no inherent data races||no shared variables|
|low overhead||each MPI process can utilize OpenMP,
resulting in a hybrid application
|can be executed/started normally||needs a library wrapper|
So in sum it really depends and if you are unsure, have a chat with your local HPC division, check out the example in the References or head over to the Support.